News Center

One-stop Solution for Valve Products

What is thermal attachment of gate valves?


Release time:

Feb 27,2025

What is thermal attachment of gate valves?

Thermal attachment of a gate valve is the phenomenon of closing a valve in a hot state and the valve failing to open when it cools down.

“Two main causes”

1. When closing the valve, the valve stem from the external low-temperature zone into the high-temperature zone inside the valve body, with the gradual heating of the valve stem, both in the axial and radial direction will produce a small amount of deformation, axial deformation generates the force F1, which further increases the closure force of the valve flap. (Refer to Figure 1)

2. When the valve body is in the high temperature area, the valve stem, valve and valve seat have different degrees of thermal expansion, valve deformation force F3, valve seat deformation force F2, this time the closing force than the valve at room temperature when the commissioning of the factory state of the closing force to be larger, when the valve body cooling, the valve stem, valve and valve seat contraction of different degrees of closure will be a further increase in the closing force, so that the valve plate jammed in the closed position. (Refer to Figure 1)

Figure 1

Wedge Gate Valves with Thermal Attachment

For wedge gate valves, either rigid or resilient, because of the different dimensions of the valve plate and seat, the thermal expansion due to temperature change is not the same, and thus the valve plate jamming occurs, which may cause the valve plate to fail to act. (Refer to Figure 1)

The severity of the effect of thermal adhesion on wedge gate valves depends on the variation of thermal expansion under the conditions of use of the valve. Thermal adhesion is very common at high operating temperatures.

Thermal Attachment of Parallel Plate Gate Valves

Due to the different valve sealing principle, parallel plate gate valves have no thermal adhesion concerns and offer significant safety features when operating at high temperatures. (Refer to Figure 2)

Parallel plate gate valve is positional sealing, the valve stem after reaching into the valve body expansion force F5 will only make the valve plate slightly downward, while the closing force between the valve plate and the valve seat does not change, the sealing specific pressure is only related to the medium pressure, the temperature effect is very small. (Refer to Figure 2)

Figure 2

When thermal contraction occurs between the cooling seals of the valve body, the spring between the plates compresses slightly and the change in sealing force is minimal, so the parallel plate gate valve does not thermally attach.

keywords